ATE LC30 Black

🏠 ATE LC30 Black – Electromagnetic device for damp walls

Wall drying – An electromagnetic solution against rising damp

Wall dampness is a common problem, often caused by rising damp. Water present in the ground naturally moves upward through the building’s porous materials such as brick, stone, or plaster. This phenomenon weakens the structure, reduces thermal comfort, and encourages mold growth.

The ATE LC30 Black is an electromagnetic anti-damp device designed to dry walls without injecting chemical products. Thanks to its polarity inversion technology, it acts directly at the source of the problem.

📘 ATE LC30 User Manuals

Download the installation manual in your language:

French – Download the manual
English – Download the manual
German – Download the manual
Italian – Download the manual
Portuguese – Download the manual
Spanish – Download the manual

⚙️ How does the ATE LC30 work?

Each wall generates a natural electrical potential that draws moisture upward. The device emits low-frequency electromagnetic pulses that reverse the polarity of these fields. Water molecules are therefore redirected downward, naturally returning to the foundations.

This process is continuous, silent, autonomous, and requires no maintenance.

✅ Benefits of the ATE LC30 Black

Coverage radius: 15 meters (30 m diameter)
No vibration, no noise, no harmful emissions
Very low power consumption: only 0.75 W (~€15/year)
Elegant, discreet black design
Manufacturer’s warranty: 10 years
Made in France
Certified to European standards (EMF, RoHS, EMC…)

📦 Technical specifications

Dimensions: 322 x 232 x 32 mm
Power supply: 12 V
Power consumption: 0.75 W
Maximum coverage: 30 m diameter
Installation: mounting on a load-bearing wall only
Certifications:

• Low Voltage Directive 2014/35/EU

• EMC Directive 2014/30/EU

• RoHS Directive 2011/65/EU

• WEEE Directive 2012/19/EU

• EMF tested – non-harmful waves (Emitech laboratory)

🎯 Effectiveness and results

When the device is installed correctly and used according to the recommendations, significant drying results are generally observed within 18 to 24 months, depending on the building’s structure, the condition of the walls, and compliance with the guidelines.

🛠️ Installation tips

Height: 30 cm to 1 m above the floor, on a load-bearing wall or internal supporting wall (preferably damp)
Distance: at least 1.50 m from other electronic devices
Mounting: hang like a picture and avoid moving it after installation
Power: must remain plugged in continuously (very low consumption)

💡 Tips to optimize drying

Remove waterproof coverings 10–20 cm above the affected areas
Ensure good ventilation: install a ventilation system or adjust door undercuts/airflow paths
After drying, brush off surface salts, then redo renders with a lime-based mortar and anti-salt additive
Plan drainage if lateral water ingress is present (hydrostatic pressure)

⚠️ Important information

This device does not treat:

• Active water ingress (roof leaks, flooding)

• Mold already present on the walls

➡️ These issues must be addressed separately to ensure long-term effectiveness.